Get A Quote

Common Furnace Issues That Can’t Be Ignored

Share on facebook
Share on twitter
Share on linkedin
Share on pinterest

Everyone wants their heaters to operate when it’s freezing outdoors. Malfunctioning or broken heating equipment forces you to wear thick coats and makes you experience a great deal of agony in the cold weather especially. However, one should understand why their heating system isn’t working and its severity so they can take adequate steps to fix it.

What Should You Do?

  • Turn Off Your System: Turning off any power supplies would be ideal. 
  • Identify The Issue: The following are some of the most typical causes of furnace failure; a lack of maintenance, broken pipes or a faulty heat exchanger, and many more.
  • Repairing The Device On Your Own: If you’ve worked on a furnace before, you might be able to address the problem independently. However, if you have no past expertise fixing furnaces, you should contact professionals like furnace repair in Hoover, AL.
  • Call a Technician: Describe the issue you’re having and schedule a service with your technician when you call. Please wait until the expert has inspected your furnace before turning it on.

What Causes a Heater To Cease Working?

There are several reasons why your furnace or heat pump may be malfunctioning. Some most common reasons are:

  • Lack of Maintenance

In most cases, the issue is simply that your furnace or heating system is dirty:

    • A clogged blower motor might cause equipment failure.
    • Clogged air filters restrict airflow and can exacerbate existing duct sizing issues.
    • A flame sensor that is clogged may prevent your heating system from lighting up.
    • Dirty burners will prevent your furnace from working correctly.
  • Too Much Gas

Manufacturers of furnaces and heat pumps have specifications for how much gas their equipment should burn. To ensure that the equipment functions correctly, you must calibrate it during installation.

  • Dead Blower Capacitor

Capacitors have tolerance, and if it falls below a specific level, the blower may not reach the required RPM.

  • Low Refrigerant Levels

If the refrigerant level in your heating system becomes too low, heat strips will turn on more frequently than you desire, causing the compressor to overheat and fail.

  • Faulty Components

Failed starting components can make the blower or exterior unit ineffective, preventing the system from heating your home.

  • Bad Draught Inducer

A draught inducer is a small motor that aids in the removal of surplus gas from the heat exchanger. It will eventually burn out if it starts to draw a lot of currents.

  • Improper Ducting Design or Installation

The issue isn’t always your heater. Your ductwork might be causing the problem. The system will eventually overheat and fail due to inefficient ducting design and installation. You may have to seek the help of a heating service in Hoover, ALso they look into the issue.

Should You Attempt a DIY?

Do not attempt a DIY unless you have prior experience delivering heating, ventilation, and air conditioning (HVAC) services. If you try a DIY without prior experience, you risk damaging smaller or more fragile pieces. It may cause the entire system to develop additional problems in the long run.

If you are looking for HVAC repair in Hoover, AL, we at Complete Air Services Inc. can help you save money on services and repair. Call us at (205)467-6229 or drop us an email today!